Corp. has reformulated and reintroduced Loctite 243 Threadlocker to
withstand temperatures up to 360F, cure consistently without primers and
tolerate contamination from thread lubrication, anti-corrosion and protection
fluids. Designed for locking and sealing fasteners that may need to be
disassembled during their service life, this anaerobic threadlocker now
provides enhanced performance on both active and passive metal surfaces
including steel, stainless steel and plated materials.
Medium viscosity Loctite 243 prevents loosening and
leakage from shock and vibration on fasteners from 1/4 to Â¾ inch in diameter. This thixotropic liquid threadlocker will not migrate
once applied to a fastener's surface. Loctite 243 fixtures in 5 minutes and
achieves full cure in 24 hours when confined in the absence of air between
close fitting metal surfaces.
Fasteners assembled using removable-strength Loctite 243
can be disassembled using standard hand tools. This threadlocker is registered
to NSF Category P1, and can be used in and around food processing applications.
Loctite 243 is available in 0.5 ml capsules, 10 ml tubes and 50 ml, 250 ml or 1
The engineers and inventors of the post WWII period turned their attention to advancements in electronics, communication, and entertainment. Breakthrough inventions range from LEGOs and computer gaming to the integrated circuit and Ethernet -- a range of advancements that have little in common except they changed our lives.
The age of touch could soon come to an end. From smartphones and smartwatches, to home devices, to in-car infotainment systems, touch is no longer the primary user interface. Technology market leaders are driving a migration from touch to voice as a user interface.
Soft starter technology has become a way to mitigate startup stressors by moderating a motor’s voltage supply during the machine start-up phase, slowly ramping it up and effectively adjusting the machine’s load behavior to protect mechanical components.
A new report from the National Institute of Standards and Technology (NIST) makes a start on developing control schemes, process measurements, and modeling and simulation methods for powder bed fusion additive manufacturing.
If you’re developing a product with lots of sensors and no access to the power grid, then you’ll want to take note of a Design News Continuing Education Center class, “Designing Low Power Systems Using Battery and Energy Harvesting Energy Sources."
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.