Allegro MicroSystems Inc.'sA1356 is a high precision, user programmable, Hall-effect linear
sensor with a pulse width modulated (PWM), open collector output. The duty
cycle (DC) of the PWM output signal (freq: 2 kHz) is proportional to an
applied magnetic field. The A1356 device converts an analog signal from its
internal Hall sensor element to a digitally encoded PWM output signal.
The BiCMOS, monolithic circuit inside of the A1356
integrates a Hall element, precision temperature-compensating circuitry to
reduce the intrinsic sensitivity and offset drift of the Hall element, a
small-signal high-gain amplifier, proprietary dynamic offset cancellation
circuits and PWM conversion circuitry. The dynamic offset cancellation circuits
reduce the residual offset voltage of the Hall element, which is normally
caused by device over molding, temperature dependencies and thermal stress. The
high-frequency offset cancellation (chopping) clock allows for a greater
sampling rate, which increases the accuracy of the output signal and results in
faster signal processing capability.
The design and manufacturing flexibility of the A1356
is realized through user programmable: gain, quiescent duty cycle and carrier
frequency. The device can be set up in a magnetic circuit and programmed with a
train of serial pulses. Once the appropriate parameters have been selected, the
codes can be locked for one-time programming. In this manner, manufacturing
tolerances can be reduced and the assembly process can be simplified.
The A1356 sensor is provided in a lead (Pb) free,
3-pin, single inline package (KB suffix), with 100 percent matte tin lead frame
plating. It is priced at $1.45 in quantities of 1,000.
Conventional wisdom holds that MIT, Cal Tech, and Stanford are three of the country’s best undergraduate engineering schools. Unfortunately, when conventional wisdom visits the topic of best engineering schools, it too often leaves out some of the most distinguished programs that don’t happen to offer PhD-level degrees.
Airbus Defence and Space has 3D printed titanium brackets for communications satellites. The redesigned, one-piece 3D-printed brackets have better thermal resistance than conventionally manufactured parts, can be produced faster, cost 20% less, and save about 1 kg of weight per satellite.
A group of researchers at the Seoul National University have discovered a way to take material from cigarette butts and turn it into a carbon-based material that’s ideal for storing energy and creating a powerful supercapacitor.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.