The Multi-Ethernet Option on the control section for the
IndraDrive supports four Master Communications: Serocs III, EtherCat, ProfiNet and EtherNet/IP.
It can be used with different master controls with out the need to use
different hardware. When OEM's are trying to meet with end-user specs they have
to make sure that all the hardware is compatible. With the IndraDrive
Multi-Ethernet option there is one less concern of compatibility, because it is
compatible with four communication protocols.
Therefore, the machine design does not need to change, stock is more
consistent, and bill-of-material does not change much. Before the IndraDrive
Multi-Ethernet, drives only had one Master communication available. If SERCOS
III was being used as Master Communication, a drive with the SERCOS III
interface had to be ordered, if another master communication was going to be
used then a drive with that specific communication protocol had to be ordered.
With the IndraDrive Multi-Ethernet option, only one drive has to be ordered and
it covers multiple (four) communication fieldbusses.
The engineers and inventors of the post WWII period turned their attention to advancements in electronics, communication, and entertainment. Breakthrough inventions range from LEGOs and computer gaming to the integrated circuit and Ethernet -- a range of advancements that have little in common except they changed our lives.
The age of touch could soon come to an end. From smartphones and smartwatches, to home devices, to in-car infotainment systems, touch is no longer the primary user interface. Technology market leaders are driving a migration from touch to voice as a user interface.
Soft starter technology has become a way to mitigate startup stressors by moderating a motor’s voltage supply during the machine start-up phase, slowly ramping it up and effectively adjusting the machine’s load behavior to protect mechanical components.
A new report from the National Institute of Standards and Technology (NIST) makes a start on developing control schemes, process measurements, and modeling and simulation methods for powder bed fusion additive manufacturing.
If you’re developing a product with lots of sensors and no access to the power grid, then you’ll want to take note of a Design News Continuing Education Center class, “Designing Low Power Systems Using Battery and Energy Harvesting Energy Sources."
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.