Design News has editors advocating for and against a bailout to
domestic automakers. Editor-in-chief John Dodge argues for a bailout
while Materials Editor Doug Smock is urging lawmakers to say NO. Check
out the coverage below, and weigh in with your thoughts and comments.
Obama Should Tell Detroit's CEOs: No The auto lobby is pushing hard
for a federal bail out right now. As much as I support American
manufacturing, I think a federal bail out for GM, Ford and Chrysler
would be a tragic mistake...
GM, Ford and Chrysler Should get Bailed Out
This is National Dump on American Automakers Week. Cash-less GM, the poster child for industrial vision-less-ness, is
bearing the brunt of the finger-pointing and accusations. So I thought
it might be interesting to look just how innovative GM is and relate it
to the bailout...
The company says it anticipates high-definition video for home security and other uses will be the next mature technology integrated into the IoT domain, hence the introduction of its MatrixCam devkit.
Siemens and Georgia Institute of Technology are partnering to address limitations in the current additive manufacturing design-to-production chain in an applied research project as part of the federally backed America Makes program.
Most of the new 3D printers and 3D printing technologies in this crop are breaking some boundaries, whether it's build volume-per-dollar ratios, multimaterials printing techniques, or new materials types.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.