This expansion to ControlAir's line of regulators is compatible with sour gas environments and adapts to offshore environments with fluorocarbon diaphragm construction and 316 stainless steel housing and filter assemblies. They use oversized valving to get a high flow rate with minimum pressure drop, and can vent hazardous gases remotely with a tapped exhaust port. It has an air consumption rate of 4 SCFH (0.1 m3 per hour), and removes solid and liquid particles down to 25 microns (5 micron option). The 350SS regulator comes in ¼ - inch NPT and ½ - inch NPT porting, and the 360SS regulator comes in ¼ - inch NPT. Four output ranges over up to 150 psig (20 BAR) outputs, with a maximum supply pressure of 290 psig (20 BAR). They come with two ¼ - inch NPT gauge ports. They work in low-temperature application ranges from -58 to +194F, or -50 to +90C. Other optional hardware is also available. ControlAir Inc.http://rbi.ims.ca/4928-604
When you think of the DARPA Robotics Challenge, you may imagine complex humanoid contraptions made of metal and wires that move like a Terminator Series T-90. But what actually happened at the much-vaunted event was something just a bit different.
Traditional dev kits are based on a manufacturer’s microcontroller, radio module, or sensor device. The idea is to aid the design engineer in developing his or her own IoT prototype as quickly as possible. A not-so-traditional IoT development kit released by Bosch aims to simplify IoT prototyping even further.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.