This fanless board uses an ultra-low-power onboard Intel Celeron processor at 650 MHz. It uses up to 348 mb of SDRAM, optional rear I/O support, battery backup RAM, and two onboard CompactFlash sockets. It also comes with a 10/100 Mbps Ethernet port, watchdog timer, a DVI-I interface, a PCI-to-PCI bridge drivers up to seven masters, battery-backup 512k RAM, two RS-232/422/485 ports, timer IRQ, and a 2.5-inch hard drive tray. It supports AC-97 audio, line-in, line-out and MCI-in. Prices start at $1,450. Advantech Corp. Industrial Automation Grouphttp://rbi.ims.ca/4928-609
The FDA has just released draft guidelines for using 3D printing in the design, development, and manufacture of regulated medical products. Although the recommendations are non-binding, they do set some much-needed parameters.
We're talking a look at 10 of the coolest technologies being developed by the US military today. In addition to saving lives on the battlefield, don't be surprised if you see some of these in your daily life some time in the near future.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.