Made for coating large structures and components such as motor housings, bag houses, cyclones, hoppers, pipelines and precipitators, this single-part, gray, low-viscosity, polymeric coating cures and dries at room temperature into a hard, non-porous and abrasion resistant material. It has survived long-term salt fog, salt spray and humidity of over 1,000 hours, and resists hydrochloric, nitric, ethylene chloride and sulfuric acids. It comes in a 200-240 cps viscosity, a specific gravity of 1.05 gms/cc, and solids by volume of 49 percent (67 percent by weight). It usually goes on by brush, roller or ordinary pneumatic spray equipment in a 4.0 mil wet film thickness, and dries to about 2.0 mils, typically covering 722 sq ft per gallon in a 1.0 mil dry film. It can also be applied directly on rusted surfaces. It comes in pint, quart and gallon containers. Aremco Products Inc.http://rbi.ims.ca/4928-624
Almost every automaker has had to 'pick a side' when it comes to alternative fuel options and ways to divest from a reliance on gasoline. Fiat is looking to back compressed natural gas or liquid propane as an interim solution.
Designing and filling a new type of water bottle might take less engineering work, but the description will help kids understand how science, math, and engineering influence their lives even through things that seem mundane.
Against a backdrop of mounting product complexity and a need to keep a lid on development costs, companies are recognizing a need to make simulation a more integral part of the design process. In response, vendors in the CAD world are building out CAE functionality as part of their CAD suites while simulation vendors are building tighter integrations to leading CAD tools. Keith Meintjes, Ph.D., Practice Manager, Simulation and Analysis at CIMdata, Inc., joins Design News CAD Editor Beth Stackpole in this radio program to explore the new face of integrated CAD and CAE, how companies are benefitting from this tighter partnership between platforms, and how integrating CAE earlier in the development cycle pays off in optimized product designs.
To save this item to your list of favorite Design News content so you can find it later in your Profile page, click the "Save It" button next to the item.
If you found this interesting or useful, please use the links to the services below to share it with other readers. You will need a free account with each service to share an item via that service.
Tweet This
7 
