Brochure describes SpectraMill(TM) M27 ball-nose end mills for cavity and contour milling in die and mold manufacturing. Radius design inserts extend the cutting surface from 180 to 230 degrees and are available in either RG (periphery ground) or RH (precision ground all over) configurations. Ball-nose end mills are available in six configurations from 0.375 inch to 1.250 inches. Information on three insert grades is also provided: THM, TTM, and TT-I25.
Valenite Inc., Box 9636, Madison Heights., MI 48071.
Industrial workplaces are governed by OSHA rules, but this isn’t to say that rules are always followed. While injuries happen on production floors for a variety of reasons, of the top 10 OSHA rules that are most often ignored in industrial settings, two directly involve machine design: lockout/tagout procedures (LO/TO) and machine guarding.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.