Meet Plastics Design Experts at Autodesk's NPE Booth

June 4, 2009

There will be a treasure trove of technical expertise on hand at the National Plastics Exposition in Chicago June 22-26. One example is a “Meet the Experts” session at the MoldflowAutodesk booth 10025 in the South Hall at McCormick Place. Here’s the daily lineup:

10:00 a.m. Using Simulation to Avoid the Pitfalls of Plastics Product Design: Professor Bob Malloy - Plastics Engineering Dept. Chair, University of Massachusetts.

10:30 a.m. Fundamental Differences in Flow, Pack, Cooling and Warp: Mike Sepe - Independent Consultant.

11:30 a.m. Fundamentals of Injection Mold Design: Robert Dealey, Dealey’s Mold Engineering, Inc.

12:00 p.m. Establishing First Stage Fill Time: John Bozzelli - Injection Molding Solutions

1:00 p.m. Fundamentals of Injection Mold Design: Robert Dealey- Dealey’s Mold Engineering, Inc.

2:00 p.m. How Moldflow Addresses Current Challenges in the Plastics Industry: Chris Czeczuga- Bozilla Corp.

Posted by Doug Smock on June 4, 2009 | Comments (0)

Design News Partner Zones

Light Matters: The Unsung Heroes of Modern Health Care
First, let's define "no-compromise." In an ideal configuration, this lamp would use a high-brightness LED (HBLED) that is built into a small, integrated package and is able to produce a large quantity of focused light, operate with a high level of reliability and generate no audible noise. Is this difficult? Yes, but it is possible.
Read More

Design Engineers' Portal for Sensing and Machine Safety
Whatever industry you're in, or whatever product you manufacture, the right sensors to automate your plant, and to improve your overall efficiency, quality and safety are a must. You'll find Banner Engineering to be an amazing resource of products, training and people with expertise.