More Blogs from Mechatronics Zone
Suppose you wanted to create a FIR filter with your own requirements. How would you find the necessary coefficients, and how many of them would you need?
Switched-capacitor filters have a few disadvantages. They exhibit greater sensitivity to noise than their op-amp-based filter siblings, and they have low-amplitude clock-signal artifacts -- clock feedthrough -- on their outputs.
This column wraps up our discussion of encoders with information about resolvers, which provide angular data over 360 degrees.
Engineers use rotary encoders to measure the angular position of an attached device or to measure distance indirectly.
The Machinist Calc Pro computes speeds and feed rates for milling, turning, and drilling: cutting speed, spindle speed, feed rate (inches/minute), cutting feed, etc.