HOME  |  NEWS  |  BLOGS  |  MESSAGES  |  FEATURES  |  VIDEOS  |  WEBINARS  |  INDUSTRIES  |  FOCUS ON FUNDAMENTALS
  |  REGISTER  |  LOGIN  |  HELP
Blogs
Mechatronics Zone

Undersampling Shifts Signal Bandwidths

NO RATINGS
View Comments: Newest First|Oldest First|Threaded View
MKsteel
User Rank
Iron
Re: Whoda thunk?
MKsteel   11/2/2012 8:39:45 AM
NO RATINGS
My guess is that some university guy was too ornery to buy an ADC that had a higher sample rate or his department chair was too cheap/too mad at him to authorize it. So necessity probably mothered this discovery.

Jon Titus
User Rank
Blogger
Re: Whoda thunk?
Jon Titus   11/1/2012 5:04:44 PM
NO RATINGS
Perhaps it was tackled for the sheer joy of watching the math unfold an effect of discrete-time sampled data.

ttemple
User Rank
Platinum
Whoda thunk?
ttemple   11/1/2012 3:17:07 PM
NO RATINGS
That is one of those things you look at and say "who on earth figured that out? (and why?).

 

Partner Zone
More Blogs from Mechatronics Zone
Suppose you wanted to create a FIR filter with your own requirements. How would you find the necessary coefficients, and how many of them would you need?
Switched-capacitor filters have a few disadvantages. They exhibit greater sensitivity to noise than their op-amp-based filter siblings, and they have low-amplitude clock-signal artifacts -- clock feedthrough -- on their outputs.
This column wraps up our discussion of encoders with information about resolvers, which provide angular data over 360 degrees.
Engineers use rotary encoders to measure the angular position of an attached device or to measure distance indirectly.
The Machinist Calc Pro computes speeds and feed rates for milling, turning, and drilling: cutting speed, spindle speed, feed rate (inches/minute), cutting feed, etc.
Design News Webinar Series
12/11/2014 8:00 a.m. California / 11:00 a.m. New York
12/10/2014 8:00 a.m. California / 11:00 a.m. New York
11/19/2014 11:00 a.m. California / 2:00 p.m. New York
11/6/2014 11:00 a.m. California / 2:00 p.m. New York
Quick Poll
The Continuing Education Center offers engineers an entirely new way to get the education they need to formulate next-generation solutions.
SEMESTERS: 1  |  2  |  3  |  4  |  5  |  67


Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.
Learn More   |   Login   |   Archived Classes
Twitter Feed
Design News Twitter Feed
Like Us on Facebook

Sponsored Content

Technology Marketplace

Copyright © 2014 UBM Canon, A UBM company, All rights reserved. Privacy Policy | Terms of Service