HOME  |  NEWS  |  BLOGS  |  MESSAGES  |  FEATURES  |  VIDEOS  |  WEBINARS  |  INDUSTRIES  |  FOCUS ON FUNDAMENTALS
  |  REGISTER  |  LOGIN  |  HELP
Blogs
Mechatronics Zone

AVR Studio 5 Includes Sensor Driver Code

NO RATINGS
View Comments: Oldest First|Newest First|Threaded View
sensor pro
User Rank
Gold
AVR studio 5
sensor pro   6/28/2011 11:10:54 AM
NO RATINGS
Great product and very helpful. i use the studio in its various versions for about 4 years. Super easy to use, and now with the addition of these drivers we are able to change some characteristics directly from the suite.

Great. Thanks again.

Charles Murray
User Rank
Blogger
Great idea
Charles Murray   6/28/2011 1:25:53 PM
NO RATINGS
Communications between sensors and MCUs is an ever-present challenge. Hats off to Atmel for actually recognizing this.

Jack Rupert, PE
User Rank
Platinum
Interesting...
Jack Rupert, PE   6/28/2011 1:44:02 PM
NO RATINGS
Interesting product suite.  I know of quite a few application that stayed away from going embedded because of fear of the driver issues.

sensor pro
User Rank
Gold
Re: Great idea
sensor pro   6/28/2011 4:49:49 PM
NO RATINGS
I forgot to add that this suite now includes acompiler. I wish other Arm and Cortex guys would do the same. It is a shame to waste $1000.00 to $5000.00 for a tool that allows to use their product.

On the other hand it is a great marketing move that will helps lots of designers.

 

Partner Zone
More Blogs from Mechatronics Zone
Suppose you wanted to create a FIR filter with your own requirements. How would you find the necessary coefficients, and how many of them would you need?
Switched-capacitor filters have a few disadvantages. They exhibit greater sensitivity to noise than their op-amp-based filter siblings, and they have low-amplitude clock-signal artifacts -- clock feedthrough -- on their outputs.
This column wraps up our discussion of encoders with information about resolvers, which provide angular data over 360 degrees.
Engineers use rotary encoders to measure the angular position of an attached device or to measure distance indirectly.
The Machinist Calc Pro computes speeds and feed rates for milling, turning, and drilling: cutting speed, spindle speed, feed rate (inches/minute), cutting feed, etc.
Design News Webinar Series
7/23/2014 11:00 a.m. California / 2:00 p.m. New York
7/17/2014 11:00 a.m. California / 2:00 p.m. New York
6/25/2014 11:00 a.m. California / 2:00 p.m. New York
5/13/2014 10:00 a.m. California / 1:00 p.m. New York / 6:00 p.m. London
Quick Poll
The Continuing Education Center offers engineers an entirely new way to get the education they need to formulate next-generation solutions.
Aug 4 - 8, Introduction to Linux Device Drivers
SEMESTERS: 1  |  2  |  3  |  4  |  5  |  6


Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.
Next Class: August 12 - 14
Sponsored by igus
Learn More   |   Login   |   Archived Classes
Twitter Feed
Design News Twitter Feed
Like Us on Facebook

Sponsored Content

Technology Marketplace

Copyright © 2014 UBM Canon, A UBM company, All rights reserved. Privacy Policy | Terms of Service