HOME  |  NEWS  |  BLOGS  |  MESSAGES  |  FEATURES  |  VIDEOS  |  WEBINARS  |  INDUSTRIES  |  FOCUS ON FUNDAMENTALS
  |  REGISTER  |  LOGIN  |  HELP
Blogs
Engineering Materials

Corn, Wheat & Rice Trash Make Concrete Stronger

NO RATINGS
View Comments: Newest First|Oldest First|Threaded View
<<  <  Page 2/3  >  >>
j-allen
User Rank
Gold
Concrete fillers
j-allen   4/16/2013 2:02:26 PM
NO RATINGS
When I was in grad school the civil engineers would enter the annual concrete canoe contest where the teams would have to build a canoe entirely out of conrete and then race it against those of other teams.  Most broke up or sank before the finish line, but the builders did use unusual fillers to reduce the density.  One mix had a specific gravity of just 0.75, about equal to oak, and it had an amazing tensile strength, almost  two percent that of oak. 

Ann R. Thryft
User Rank
Blogger
Re: Corn, Wheat & Rice Trash Make Concrete Stronger
Ann R. Thryft   4/16/2013 11:56:04 AM
NO RATINGS
Thanks, Greg, for those examples. Mud brick goes back at least as far as ancient Mesopotamia in the Near East.

Ann R. Thryft
User Rank
Blogger
Re: Replenish the Soil?
Ann R. Thryft   4/16/2013 11:54:33 AM
NO RATINGS
You're absolutely right about "specific chemical requirements," which is what I said. But there's cellulosic and then there's cellulosic: they're by no means all the same. And the stuff we're writing about here is not leaf mold--which, BTW, can also vary widely in chemical content (for example, high tannin content in oak leaves).
Depending on its chemical composition, some cellulosic material adds nitrogen and other nutrients to the soil, some takes those out, and some doesn't do anything nutritionally, but does add bulk and loft, which is not always needed or wanted, BTW. The stuff being recycled here doesn't add much in the way of nutrients and/or can leach it out. It can also cause rot problems. This is a complex subject, which we touched on in the DuPont article. Check it out.

Elizabeth M
User Rank
Blogger
Re: Interesting use of these resources
Elizabeth M   4/16/2013 3:51:02 AM
NO RATINGS
Thanks for those links, Ann. I do remember reading your previous coverage, but always good to jog the memory, as one reads about so much. It's good to see this successful model being used and reused.

JGetaz
User Rank
Bronze
Re: Replenish the Soil?
JGetaz   4/15/2013 3:59:56 PM
NO RATINGS
All gardeners know what they buy in a store - the synthetic, or maybe not, fertilizers I mentioned - have specific chemical requirements. Good gardeners also swear by leaf mold: cellulosic material partly consumed by mold that they turn under in the spring to give the soil more tilth. Sounds like what we're taking away from the soil this way.

Ann R. Thryft
User Rank
Blogger
Re: Interesting use of these resources
Ann R. Thryft   4/15/2013 3:44:14 PM
NO RATINGS
Elizabeth, the model of using waste plant material for making biofuel and bioplastics is already well underway, as we've covered in several posts in DN. One is the DuPont story about biofuel:
http://www.designnews.com/author.asp?section_id=1392&doc_id=257126
Another is using cane trash to make bioplastics:
http://www.designnews.com/document.asp?doc_id=237554

Ann R. Thryft
User Rank
Blogger
Re: Replenish the Soil?
Ann R. Thryft   4/15/2013 3:43:31 PM
NO RATINGS
Not all farmers want to recycle this stuff, for several different reasons (one being that cellulosic material doesn't make very good fertilizer, which has very specific chemical requirements, as any gardener knows). Some of them are covered in the story we did on DuPont using corn stover for making biofuel--we gave the link in this story, but here it is again http://www.designnews.com/author.asp?section_id=1392&doc_id=257126

Greg Stirling
User Rank
Platinum
Corn, Wheat & Rice Trash Make Concrete Stronger
Greg Stirling   4/15/2013 3:40:28 PM
NO RATINGS
Excellent use for recycled materials.  Concrete has been reinforced for eons to make it stronger or lighter.  From adding straw to mud bricks in thy neighbors hut, steel rebar in just about everything cast concrete, to adding limestone or pumice (lavarock) in the concrete domed cielings of ancient structures such as the Parthenon.  A building which has survived earthquakes and other factors for 1900+ years...

Elizabeth M
User Rank
Blogger
Re: Interesting use of these resources
Elizabeth M   4/15/2013 2:55:29 PM
NO RATINGS
When you put it that way, Ann, I definitely hope there will be other applications of this model! Surely something like this is already happening in the biofuel world?

JGetaz
User Rank
Bronze
Replenish the Soil?
JGetaz   4/15/2013 2:05:33 PM
NO RATINGS
I would have thought it would be better to turn any such "waste" under to replenish the organic material in the soil. Since it is cellulosic, I would think this would also help keep the soil loose. This should make it a little less important to put synthetic fertilizers on the ground the next spring. 

<<  <  Page 2/3  >  >>
Partner Zone
More Blogs from Engineering Materials
Last week, the bill for reforming chemical regulation, the TSCA Modernization Act of 2015, passed the House. If it or a similar bill becomes law, the effects on cost and availability of adhesives and plastics incorporating these substances are not yet clear.
The latest crop of coating and sealant materials and devices has impressive credentials. Many are designed for tough environments with broad operating temperature ranges, and they often cure faster, require fewer process steps, and produce less waste.
A new program has been proposed for testing and certify 3D printing filaments for emissions safety. To engineers who've used 3D printers at home this is a no-brainer. It's from a consumer on Kickstarter, and targets use in homes and schools.
For the last 50 years, the Metal Powder Industries Federation (MPIF) has sponsored an awards competition for creative solutions to designing and fabricating near-net-shape parts using powder metal (PM) technologies. Here are the seven Grand Prize winners of the 2015 contest.
Graphene 3D Lab has added graphene to 3DP PLA filament to strengthen the material and add conductivity to prints made with it. The material can be used to 3D print conductive traces embedded in 3D-printed parts for electronics, as well as capacitive touch sensors.
Quick Poll
The Continuing Education Center offers engineers an entirely new way to get the education they need to formulate next-generation solutions.
Jul 6 - 10, Building Raspberry Pi Controllers with Python
SEMESTERS: 1  |  2  |  3  |  4  |  5  |  6 |  7


Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.
Learn More   |   Login   |   Archived Classes
Twitter Feed
Design News Twitter Feed
Like Us on Facebook

Sponsored Content

Technology Marketplace

Copyright © 2015 UBM Canon, A UBM company, All rights reserved. Privacy Policy | Terms of Service