Out-of-phase detectors produce two pulse signals that indicate relative rotation as well as direction for an incremental encoder. Counting edges or monitoring binary values can increase resolution fourfold.
Great article - I particularly liked the mention of using hall effect sensors. Makes sense since historically they have been used as rotary position gear tooth sensors such as crank and camshaft sensing in automotive applications. They are usually a lot cheaper than optical encoders too.
Hello, TJ. As far as I can tell, the magnetic field for a Wiegand detector must be very localized, so magnetic interference shouldn't become a problem. Resolvers get used with equipment that uses electric motors, so I bet the manufacturers have added shielding as needed. Worth asking about before you buy a resolver, and worth the time to run some tests in proximity to specific equipment.
In my applications, I often need an axis with a hollow bore, so the position encoder either needs to be hollow. From what I can tell, the Wiegard effect only works when the rotating magnet axis of rotation is centered about the Wiegard wire. I'm sure I've misunderstood the tech in some way and hope that my understanding is wrong.
If my understanding is wrong and the axial rotations do not have to align, then I'd be inclined to merge an optical absolute encoder with a Wiegard sensor for counting rotations. You'd get the resolution of optical with the persistent turn counting of the Wiegard sensor.
I hope to see more of the Wiegand effect encoders in the near future. It might be a good alternative to optical encoders in a closed loop stepper motor system. Which, by the way, are getting cheap enough for anyone to buy.
Siemens and Georgia Institute of Technology are partnering to address limitations in the current additive manufacturing design-to-production chain in an applied research project as part of the federally backed America Makes program.
Independent science safety company Underwriters Laboratories is providing new guidance for manufacturers about how to follow the latest IEC standards for implementing safety features in programmable logic controllers.
Automakers are adding greater digital capabilities to their design and engineering activities to promote collaboration among staff and suppliers, input consumer feedback, shorten product development cycles, and meet evolving end-use needs.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.