University of Washington’s Ambient Backscatter device is equipped with an antenna that picks up broadcast signals from TV or cellular sources and converts them into hundreds of microwatts of electrical power. (Source: University of Washington)
The simple fact that you can access cellular and other networks from practically every part of the world is a clear indication that we are surrounded all over by digital signals, even in spite of the fact that we cannot actually see the signals. The ability to harness these signals for alternative power is a great step forward. Hope they also considered how such harnessing will affect the normal use of those signals because I wouldn't want to have no cellular network for a battery-free iPad.
Recovering power from the ambient electrostatic field is not new by any stretch. Way back in the sixties Popular Electronics Magazine published plans for a "free power" radio that used a fairly high "Q" tuned circuit to capture enough energy to power a 1 transistor amplifier for a crystal detector radio. Of course, now we have a much more intense field with far more frequencies then we had back then. So it is no surprise that devices to capture a bit of that energy are developed. The challenge is in the logistics, since the source impedance is very high, which limits the current available from any antenna that is a convenient size. But to see just how much signal is available, just grab the signal terminal on a scope probe, after setting the gain to one volt per division. Most areas will show several volts delivered into that 10 megohm connection. And even a direct connection will usually display over a volt. So the field is there and available, the challenge is in creating an economical way to access it. Of course there is the challenge that in the event of another power outage most of that field vanishes. But what does one expect for free?
Absolutely agreed. Sadly, I think we are far from having security in embedded devices. I just read that the closed, proprietory real time software used to manage RF radios in cell phones (and other things) is rife with security loopholes, and exists in every cell phone (and probably many medical devices).
Replace "goverment" with "computer hackers"... "Demand Response / turn off" off a city or some customers and one can see potential for mischief. Wireless security must be baked into any system, especially when it supports life safety, like the electrical grid.
There is a prevailing view that government == bad, and ceding any form of control to the government is therefore bad. This view often gets conflated with "anyone or anything that exerts some control on me is government".
It can be easily demonstrated that staggering the switch-on of domestic air-conditioners reduces the base-load of the grid by a significant amount - often enough to obviate bringing more generation on-line - all without a noticeable change in people's comfort level, in fact without any measurable temperature changes at all.
Rather than looking at this as some form of rationing, I think it is more akin to orderly queueing. If we have to serve everybody at exactly the same time, I need far more capacity than if I choose to serve only a few at a time.
This is above and beyond the possibilities for actual adjustments of home temperature (allowing AC two degrees hotter when you are not home for example - or heaven forfend - allowing ourselves to get a little hotter in the summer and a little cooler in the winter).
naperlou, Demand Response with a smart meter could only turn your house all the way on or all the way off. That's what I'm against. My electricity rates are very reasonable and honestly it would take a large incentive from the power company for me to be willing to participate in demand response even on my air conditioning.
I'm actively involved in the Demand Response (and Synchronous Reserve) participation at a large industrial facility, so I'm well versed with the programs and the payments.
As for the government comment, I don't think that I'm off base at all. Executive orders from the top are reshaping the energy generation capability of our country in a negative way, causing many large coal fired generating stations to be shut down. And the hoops required to open or even keep open existing nuclear power plants are onerous. Not permitting these plants to operate is what is going to cause brownouts and blackouts, not me running my air conditioning in August.
I do agree that increased efficiency of consumer goods a great thing, but saving milliwatts only goes so far when we don't have enough power plants in operation.
Jim_E: demand response is an important part of making the system more robust. On the other hand, the smart meter on your house can, in general, only be used to turn your whole house on or off. Of course that could be done by a guy in a truck with the old system.
Real demand response in the home requires that you put control devices on individual appliances to allow them to be turned on and off from a remote location. It might even be something you would want to do yourself. In addition, with pricing informaton available, you could optimize your electrical usage to minimize your costs. You make the choice. Pay more to get it done now, or wait until it is cheaper. What is your problem with that?
Let me ask another question. Which would you prefer, a full black out or having your air conditioner turned off for a couple of hours? I think you would prefer the later.
Your comment about government is also off base. As far as I am aware, most electricity in the United States is provided by investor owned utilities. These tend to do a fairly good job of keeping the lights on. Energy supply in the US is also not a problem on the electrical side. In fact, since we are becoming more efficient, rates are going up because the investor owned utilities must be able to recover their investment. Just think about it. Every appliance, computer, and other electrical device in your home is more efficient than the item it replaces.
Chuck, yes, this technology has been used for a while. It is the basis for all "passive" RFID tags. There are active tags. The RFID device in my car that automatically pays tolls is one. I expect it is the speed and distance that are issues there. On the other hand, most tags are passive and many are "printed".
Just not a local or onboard one. To say that these are "communications devices without the need for batteries or other power sources." is thus inaccurate, and misleading at best. Since they are powered by transmitter(s) located remotely the article should state "without the need for batteries or other local power source."
I don't know if I'm against "Smart Meters", but I am against a meter which can remotely turn off my electricity when I don't want it off....
The usage monitoring part I'm fine with, but I don't want my house to become part of the Demand Response grid! I'm involved with Demand Response at work, and have no desire for it to come to my house. Especially if it's the result of poor government politics limiting our energy supply tactics!
Samsung's Galaxy line of smartphones used to fare quite well in the repairability department, but last year's flagship S5 model took a tumble, scoring a meh-inducing 5/10. Will the newly redesigned S6 lead us back into star-studded territory, or will we sink further into the depths of a repairability black hole?
In 2003, the world contained just over 500 million Internet-connected devices. By 2010, this figure had risen to 12.5 billion connected objects, almost six devices per individual with access to the Internet. Now, as we move into 2015, the number of connected 'things' is expected to reach 25 billion, ultimately edging toward 50 billion by the end of the decade.
NASA engineer Brian Trease studied abroad in Japan as a high school student and used to fold fast-food wrappers into cranes using origami techniques he learned in library books. Inspired by this, he began to imagine that origami could be applied to building spacecraft components, particularly solar panels that could one day send solar power from space to be used on earth.
Biomedical engineering is one of the fastest growing engineering fields; from medical devices and pharmaceuticals to more cutting-edge areas like tissue, genetic, and neural engineering, US biomedical engineers (BMEs) boast salaries nearly double the annual mean wage and have faster than average job growth.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.