Nice story, Elizabeth. Interesting that wind could deliver half the world's energy needs by 2030. I'm sure that would require advances in technology. This window-based energy collector may be a contribution to that.
"You don't normally find a wind turbine in the middle of a large metropolitan area, .......... has developed a wind turbine that can be positioned between, or atop, skyscrapers and large buildings to harvest wind areas in urban areas."
Elizabeth, but in my country we can see small wind mills over most of the buildings as a part of hybrid power generator. They used to install small turbine type windmill (hybrid mode) along with solar panels to generate power.
Rob, but windmills may not be suitable for all cities or places. I my place we had implemented wind farms at certain areas, where wind is available atleast for 200 days/year. Other areas EB (Electricity Board) has instated solar panels for power generation. In certain places, they had implemented hybrid model, consisting of both windmill and solar.
This has be done before it's commonly referred to the 'ladder mill'. Or, maybe I should say it has not been done, but has been patented several times as far back as 1972. The reason it has not be done, is because it's not an efficient way to extract power from air flow.
If you were going to spend money to extract power from air flow, you would compare this to a rotating blade an see that the return on investment dictated a rotating blade. Then you might think about a vertical axis wind turbine and see that the return on investment dictated a horizontal axis wind turbine. You might think about putting a shroud, end plates, funnels, or whatever on your wind turbine and find that it would be much cheaper to simply extend the blades a little longer.
There is a reason all wind turbines look pretty much alike, the laws of physics and economics dictate how they look.
This may be very good in the concrete canyons in many large cities. The channelling effects of the buildings will raise the wind speeds. The channeling may help with the inability to turn the generator to face the wind. This generator may be less of a problem with bird strikes than the rotating propeller type turbines.
You are probably right with almost all of your comments, but not so much in the case of the vertical axis turbine. Our pitch-controlled vertical machine has a Cp higher than any traditional horizontal-axis turbine commercially available. It is also quieter, more bird friendly, and easier on the eyes than traditional machines. Unfortunately we only make a 70kW version at the moment.
Good point, My Design. Do you know what cities may be good choices for wind energy? Here in Albuquerque, we have a windy spring, but I don't believe we top 200 windy days. The need for consistent wind could create barriers to wind energy collection.
The company says it anticipates high-definition video for home security and other uses will be the next mature technology integrated into the IoT domain, hence the introduction of its MatrixCam devkit.
Siemens and Georgia Institute of Technology are partnering to address limitations in the current additive manufacturing design-to-production chain in an applied research project as part of the federally backed America Makes program.
Independent science safety company Underwriters Laboratories is providing new guidance for manufacturers about how to follow the latest IEC standards for implementing safety features in programmable logic controllers.
Automakers are adding greater digital capabilities to their design and engineering activities to promote collaboration among staff and suppliers, input consumer feedback, shorten product development cycles, and meet evolving end-use needs.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.