Early robotic hands were developed in part to mimic human grasping, but mostly to function in industrial environments where speed and force of operation were primary objectives.
More recently, some robot hand R&D has focused on closely emulating the human ability to pick up; manipulate; and move small, delicate objects in unstructured environments outside the factory safety cage. Many of these robots are being developed for use with humans, either in industrial environments, or as service robots for the elderly or disabled.
This requires robots that are smaller, safer, and human-aware at some level. Engineers developing the newer generation of robotic hands have re-thought the approach to hand design. Many have started with a higher-level view that attempts to emulate multiple integrated human biological systems, not only motor movements. The newer generation of robotic hands closely models the human hand's kinematics with a similar form factor, tactile and sometimes optical sensors, and high degrees of freedom (DOF) counts. Many have industry-standard interfaces and can be used as a tele-operation tool or mounted on a range of robot arms as part of a robot system. Some are commercially available, some were developed as proof-of-concept, and some are still in R&D.
Click on the image below to see 11 of these robots.
Based on the DLR Hand II, the German Aerospace Center (DLR) and the Harbin Institute of Technology (HIT) jointly developed the DLR/HIT Hand II as a medium-cost multisensory robotic hand. The DLR/HIT Hand II has five fingers, each with three actuators, that are identical except that one of them has an additional drive to make it work as an opposing thumb. To fully emulate human fingers' motor functions, each finger has four joints, not three, and each joint has force and position sensors. The DLR/HIT Hand II has a total of 15 degrees of freedom (DOF), compared to 13 in the original DLR Hand II. Fingers are equipped with slip-resistant gripper surfaces. Integration of drives and electronics within the hand itself is intended to make it easier to mount on a wide variety of robot arms.
(Source: German Aerospace Center (DLR))
“It's amazing the amount of research and effort going into this area.”
@apresher: Exactly some amazing robotic stuff. I fear that the world might not need humans to do work hereafter. A plus as well as a risk that might hit the world if it not being used properly.
Last week, I visited Worcester Polytechnic Institute's robotics department. WPI was the firs university in the nation to offer a BS degree in robotics. See my first of two reports in Students Design Robots.
This report looks at the over all program. Tomorrow's will look at a specific project.
Isn't that true, Chuck? Making robotic movements fluid is still something that engineers need to work on. I saw this recent story that was quite interesting...about a robotic arm that creates delicate art: http://www.fastcodesign.com/1671977/watch-delicate-art-made-with-a-massive-robotic-arm#1
There is currently much discussion around the term "platform," which may be preceded by the adjectives "mobile," "wearable," "medical," "healthcare," etc. However, regardless of the platform being discussed, they usually have one key aspect in common: They tend to be wireless. So, why is this one aspect so fairly universal? The answer is convenience.
Everyone has a MEMS story. For most of us it’s probably the airbag that saved our lives or the life of a loved one. Perhaps it’s the tire pressure sensor that alerted us about deflation before we were stranded alone on a dark muddy road.
Bioimimicry is not merely a helpful design tool -- it also encourages designers to think not only about how to solve design problems by imitating nature, but how to make the products, materials, and systems they design more ecologically sound and nature-friendly.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.