We've written about several different robot swarms, such as the team that played Beethoven, another group that danced to light and music at Cannes, and a third that's worked as a construction gang. A new swarm from Stanford University, working with NASA's Jet Propulsion Laboratory and the Massachusetts Institute of Technology, joins a different class of robots that are helping to explore space.
The swarm consists of a mother craft described as the size of a coffee table (does anyone still have those?), and smaller rovers that look like white spheres with all-over Mohawks, measuring just under 20 inches in diameter. The Stanford-led team is developing the mothership-rover system to explore moons and asteroids. The mothership would carry one or more rovers, dubbed "hedgehogs," to their destination, disgorge them, and orbit the moon or asteroid while the hedgehogs do their jobs. All craft would be powered by solar panels.
A robot swarm has been developed by Stanford University as a mothership-sphere system to explore planetary moons and asteroids. (Source: Dept. of Aeronautics and Astronautics, Stanford University)
The hedgehogs would gather detailed data, such as using microscopes to measure fine crevices and fissures in the terrain. Meanwhile, the mothership will not remain idle: It might conduct large-scale measurements, such as determining the surface concentration of chemical elements and compounds.
Hedgehog rover craft have been designed as spheres to overcome the challenges of exploring bodies with much lower gravity than a planet's. The first mission will be to Mars's moon Phobos. Its gravity is 1,000 times weaker than that of Mars. In that kind of environment, wheels are likely to lose traction, so team members designed the rovers to rely on airborne motion.
Inside each hedgehog are three rotating flywheels, each aimed in a different direction. The spinning disks' inertial forces let the spheres move with precision in an environment where traditional rovers would bounce or float uncontrollably. By quickly accelerating, the acrobatic spheres can hop for long-range ground coverage. Spinning them faster makes them bound. A slight acceleration makes them tumble, used for fine movements.
The mothership, called the Phobos Surveyor, and hedgehogs will work closely together to initiate and continue the mission. After launching the first sphere, the Phobos Surveyor and the sphere jointly determine its location and orientation, and then map its trajectory. As the hedgehog relays data back to the Surveyor, the mothership in turn sends it to scientists on Earth. Their analysis determines whether up to four or five more hedgehogs will be released, where they will go, and what information they will gather. An entire mission could last two to three years.
The researchers, led by Marco Pavone, an assistant professor in Stanford's Department of Aeronautics and Astronautics, have already constructed two generations of rover prototypes. They expect to test the third-generation hedgehog next summer in a test site that will mimic low-gravity conditions as closely as possible. In two to four years tests will be done of the Phobos Surveyor.
In March, the team will present a paper describing the project at the 2012 IEEE Aerospace Conference in Big Sky, Montana. A presentation can be accessed here and a detailed project report here.
Ann, This is a fascinating development project. But I'm not sure how movement is actually generated. And how much power is available through use of solar panels? Very interesting.
Without a doubt. Science fiction has been the inspiration for a lot of the tech we take for granted today. Take the first-person-shooter games many play today. Arguably, they date back to id software's Wolfenstein 3D. Modern ways of thinking about 3D came from id software's John Carmack. In the book "Masters of Doom," Carmack admitted that Star Trek Next Generation's "holodeck" was his ultimate goal. Though, the gaming tech never achieved that goal, Carmack still believes it will happen.
Carmack and id software are backing the Oculus Rift gaming headset with a special version of Doom 3 BFG Edition. The goggles feature the widest field of view than any other headset in history. A step closer to Carmack's goal of real virtual reality.
Wow, this is quite a wild concept...like a robotic Borg from Star Trek but with their very own mothership. Amazing if this project actually goes all the way and these hedgehogs are out there exploring the universe.
Yes, it's pretty well known that sci-fi has been the inspiration for a lot of modern technology over the last 50-plus years. That's been especially true for Star Wars and Star Trek.
Come to think of it some technology may have been inspired by fantasy novels, as well as sci-fi. For instance, I'm re-reading Tolkien's Lord of the Rings, and the Palantir might be seen as a wireless video-conferencing system.
freisl, I like that idea--sort of like space Roombas. We certainly need a lot of them! Here's an article we did on a robot system DARPA is working on to recycle space junk: http://www.designnews.com/author.asp?section_id=1386&doc_id=249134
Lets imagine that on earth we were deluged with coffee tables deploying hundreds of little spiked things from the sky raining down on us. It would certainly be the end of civilization as we know it. CNN would be interviewing some govt. bureaucrat or better still the presidents "spokes person" that would be trying to tell us it was no big deal while the Army, Navy, Airforce, etc from every country on earth would be on high alert accusing every other country on earth of doing it. Countries would instantly start bombing each other (imagine North and South Korea). Israel would accuse Iran of doing it while Iran would of course be denying it.
May be that is what the Mayans predicted but just had their math off a little.
Only something like this could be developed by our stupid govt.
There are several serious challenges relative to cleaning up space debris, and several of those challenges are quite daunting.
First, those chunks of whatever are all orbiting quite rapidly, and they weigh quite a few pounds. So intercepting them is a lot like catching large bullets. Consider what it would take to catch a baseball moving at 1000MPH. Many of the fragments are that heavy, and moving quite a bit faster.
Next, these chunks of junk are in various orbits, they are not just sitting there waiting to be captured. And when they are caught, consider the amount of energy transferred. So after acquiring one of these targets, catching it could be very exciting. Then there is the question of what to do with it once you have it. At least one sattelite was designed to capture one item and then burn up during re-entry. Quite effective but very expensive.
William K is right, catching debris is too expensive even if it's remotely possible. But he also points to a lower cost concept.
What if low mass debris is not caught, but redirected, perhaps to a "burn on re-entry" trajectory. Then the little sweeper goes off to nudge another little nut or bolt to oblivion.
(I'm imagining it would know enought not to step in front of one coming toward it.)
All the while it could be relaying sensory data as its primary objective.
You are spot on, freisl. I suggest we take it another step and add Crowdsourcing and Gamification. I say we have a company launch a low-orbit satellite that contains a fantastically-large supply of Hedgehog Sweepers that can be controlled from a smartphone app here on Earth. Users would download the app and then aim and control the trajectory of a Hedgehog Sweeper to nudge a piece of space junk into the atmosphere using an app having game play similar to Angry Birds. In-app upgrade purchases of additional sensors and controls along with advertising would help to defray the costs of the entire program while performing a needed service to humanity's future endeavors in space. I think I would even be willing to pay $2.99 for the Angry Hedgehogs app...
I think that I detect a lack of information about what is needed to track a chunk of debris traveling at 1700MPH, and perhaps a need to investigate the kinetics involved with deflecting such a particle.
For a much simplified example, imagine attempting to defrlect a golf ball that has just been hit by a strong golfer using a heavier driver club. There would be quite a few challenges.
Great idea, Willliam. What we need is to harness the excess energy and time of gamers to clean space debris, consume poisons from the environment, optimize freight routings and a host of logistic endeavors. Just turn them into games and the problems would be solved in no time.
You are behind the times, Scott. I, myself, have saved the galaxy numerous times. We space warriors don't have time to clean up space trash or save the environment when there are so many forms of intelligent space monsters trying to invade the earth. It takes all our waking hours to keep humans safe.
You are behind the times, Scott. I, myself, have saved the galaxy numerous times. We space warriors don't have time to clean up space trash or save the environment when there are so many forms of intelligent space monsters trying to invade the earth. It takes all our waking hours to keep humans safe.
We looked at a number of sources to determine this year's greenest cars, from KBB to automotive trade magazines to environmental organizations. These 14 cars emerged as being great at either stretching fuel or reducing carbon footprint.
Researchers at MIT and Sandia National Labs have observed a reaction in lithium-air batteries that could help improve the design of these cells for electric vehicles and other applications.
Healthcare might seem to be an unlikely target application for the Internet of Things technology, but recent developments show small ways that big-data is going to make an impact on patient care moving into the future.
As energy efficiency becomes more and more a concern for makers of electronics devices, researchers are coming up with new ways to harvest energy from sound vibration, footsteps, and even electromagnetic fields in the air.
From Dell / Intel® New Paradigms in Design Work Scott Hamilton, vertical market strategist for Dell Precision workstations, 5/2/2013 3
Early in my career, I worked as a draftsman and remember the days of drawing on vellum with numbered pencils and Mylar with plastic lead. This was a fun experience in the sense that I ...
I've been using workstations for more than 10 years and love finding ways to get more performance from my system. With demanding professional applications that require more power each ...
A lasting memory from my first job as an engineer in an auto assembly plant is standing on hard concrete at six in the morning, vending-machine coffee clutched in hand, listening to ...
A quick look into the merger of two powerhouse 3D printing OEMs and the new leader in rapid prototyping solutions, Stratasys. The industrial revolution is now led by 3D printing and engineers are given the opportunity to fully maximize their design capabilities, reduce their time-to-market and functionally test prototypes cheaper, faster and easier. Bruce Bradshaw, Director of Marketing in North America, will explore the large product offering and variety of materials that will help CAD designers articulate their product design with actual, physical prototypes. This broadcast will dive deep into technical information including application specific stories from real world customers and their experiences with 3D printing. 3D Printing is
To save this item to your list of favorite Design News content so you can find it later in your Profile page, click the "Save It" button next to the item.
If you found this interesting or useful, please use the links to the services below to share it with other readers. You will need a free account with each service to share an item via that service.
Tweet This
0 
