HOME  |  NEWS  |  BLOGS  |  MESSAGES  |  FEATURES  |  VIDEOS  |  WEBINARS  |  INDUSTRIES  |  FOCUS ON FUNDAMENTALS
  |  REGISTER  |  LOGIN  |  HELP
Blogs
Blog

My Opinion on IEC 61508: It Puts Safety First

NO RATINGS
View Comments: Newest First|Oldest First|Threaded View
William K.
User Rank
Platinum
IEC 61508
William K.   11/7/2012 8:54:52 PM
NO RATINGS
What the write-up does not include is just what sort of products the standard applies to. For our products it would seem that writing the control code so that any deviation from the correct sequence of actions stops everything may already be in compliance. That type of programming did not make any distinction between deviations that were unsafe and those that had no safety impact at all. Any deviation was a show-stopper.

But then I have also seen other safety rules, mostly hardware,  that seem to be aimed at drunks bent on self-destruction. Perhaps those standards should be revisited now.

naperlou
User Rank
Blogger
Software safety key
naperlou   11/6/2012 10:25:48 AM
NO RATINGS
Rich, I sympathize  with you as far as the kids go.  It is tough. 

As far as safety, it is imperative in many of the systems we interact with in these times.  If safety is not built in, people will not trust them.  Fortunately we have standards like IEC 61508.  In aerospace, you have similar standard, like DO-254.  The safety record of those systems is very good. 

Partner Zone
More Blogs
Valentine’s Day seems like a good time to recognize those folks around us who have had a hand in our success.
Makers of industrial PCs are continuing to take advantage of Moore’s law expansion of processing power enabling creative automation and control schemes with multicore processors.
The designer can now analyze temperature distribution in a design, tracking input and output of heat loads, and also turn it into a thermal stress study.
The Internet happened.” Those three words spoken yesterday by Marc Ostertag, North America president of B&R Automation at Pacific Design & Manufacturing, now taking place in Anaheim through Feb. 11, continues to bring ever-lasting changes to our ways of life and will undoubtedly transform manufacturing.
A panel session on the advanced manufacturing workforce at the Pacific Design and Manufacturing show in Anaheim this week revealed a major skills gap.
Design News Webinar Series
1/28/2016 11:00 a.m. California / 2:00 p.m. New York
12/8/2015 11:00 a.m. California / 2:00 p.m. New York
2/18/2016 11:00 AM PT | 2:00 PM ET
2/24/2016 11:00 AM PT | 2:00 PM ET
Quick Poll
The Continuing Education Center offers engineers an entirely new way to get the education they need to formulate next-generation solutions.
Jan 11 - 15, Designing ARM Devices Using Segger Tools
SEMESTERS: 1  |  2  |  3  |  4  |  5  |  6 |  7 | 8 | 9


Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.
Learn More   |   Login   |   Archived Classes
Twitter Feed
Design News Twitter Feed
Like Us on Facebook

Sponsored Content

Technology Marketplace

Copyright © 2016 UBM Canon, A UBM company, All rights reserved. Privacy Policy | Terms of Service