MATERIALS: Master Bond’s newly developed EP42HT 2ND2 has a paste-like consistency and facilitates the adhesive’s application when bonding vertical surfaces. This no-run two part epoxy fully complies with the testing requirements for USP Class VI biocompatibility. EP42HT 2ND2 cures readily at ambient temperatures and exhibits superior thermal stability for service up to 450F. It forms high strength bonds that are unaffected by sterilization processes such as radiation, ethylene oxide, chemical sterilants and steam, along with outstanding resistance to inorganic and organic acids, alkalis and organic solvents.The cured biocompatible epoxy adhesive is an excellent electrical insulator with a volume resistivity greater than >10 14 ohm-cm. While EP42HT 2ND2 is a superior adhesive, sealant and coating, it is also castable to thicknesses exceeding 2-3 inches. A post cure of 200-266F for two to three hours enhances physical properties including heat resistance. As a no drip formulation EP42HT 2ND2 provides a precise and clean bonding solution for the vertical surface set ups often found in medical assemblies.
Master Bond is a premier medical grade adhesives manufacturer offering an extensive line of medical device adhesives, sealants and medical coatings. One and two-part medical adhesive systems specifically designed for use in both disposable and reusable medical devices stand up to standard disinfectants and sterilization procedures. Medical epoxy systems meet USP Class VI biocompatibility standards.
When you think of the DARPA Robotics Challenge, you may imagine complex humanoid contraptions made of metal and wires that move like a Terminator Series T-90. But what actually happened at the much-vaunted event was something just a bit different.
Traditional dev kits are based on a manufacturer’s microcontroller, radio module, or sensor device. The idea is to aid the design engineer in developing his or her own IoT prototype as quickly as possible. A not-so-traditional IoT development kit released by Bosch aims to simplify IoT prototyping even further.
Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.