These last few years I've been using an electric bicycle for my daily commute and converted my lawn mower to solar (the idea of a green lawn mower just seemed obvious). The efficiency of motors and motor controllers have advanced to the point of being very well-suited for transportation but energy storage is still lagging. The promise of doubling the capacity of the current battery systems would place the energy storage at the same technological level as the power plant and make e-vehicles practical. I couldn't help but notice the very cautious tone of the article, though. There are lots of questions for the future; can the cell produce high drain and deep cycle life without damage, and can the manufacturing process sustain high production levels. This is a company to watch in the future.
Love to hear these tales of startups with a new low-cost, high-energy density battery story to tell. Given all the research and R&D dollars being poured into electric car battery research, my guess is we have to be nearing the point where a lot of the early disappointments either have evolved or are being replaced with new startups and technologies that are much closer to the mark of advancing the cause. Afterall, each failure or disappointment points up valuable lessons learned that can then be applied to the next round of developments that get battery density and cost closer to where we want to go.
This is good to hear. The technology is badly needed in our society. My sole question is: can our grid handle a large percentage of cars going electric? All around the USA I see a steady increase in the cost of electricity. Am I the only one that is itching to invest in solar and electric generation in general? Another application this can be put into is off the grid Energy storage. Off the grid Inverters are cheaper. Emergency power might act as secondary storage for the grid too. I honestly see the future grid requiring Grid-tie solar or wind systems to come with a certain rating of battery power. Eventually the grid will become too erratic for our slow turning turbines to match.
From Dell / Intel® New Paradigms in Design Work Scott Hamilton, vertical market strategist for Dell Precision workstations, 5/2/2013 3
Early in my career, I worked as a draftsman and remember the days of drawing on vellum with numbered pencils and Mylar with plastic lead. This was a fun experience in the sense that I ...
I've been using workstations for more than 10 years and love finding ways to get more performance from my system. With demanding professional applications that require more power each ...
A lasting memory from my first job as an engineer in an auto assembly plant is standing on hard concrete at six in the morning, vending-machine coffee clutched in hand, listening to ...
A quick look into the merger of two powerhouse 3D printing OEMs and the new leader in rapid prototyping solutions, Stratasys. The industrial revolution is now led by 3D printing and engineers are given the opportunity to fully maximize their design capabilities, reduce their time-to-market and functionally test prototypes cheaper, faster and easier. Bruce Bradshaw, Director of Marketing in North America, will explore the large product offering and variety of materials that will help CAD designers articulate their product design with actual, physical prototypes. This broadcast will dive deep into technical information including application specific stories from real world customers and their experiences with 3D printing. 3D Printing is
To save this item to your list of favorite Design News content so you can find it later in your Profile page, click the "Save It" button next to the item.
If you found this interesting or useful, please use the links to the services below to share it with other readers. You will need a free account with each service to share an item via that service.
Tweet This
19 
