HOME  |  NEWS  |  BLOGS  |  MESSAGES  |  FEATURES  |  VIDEOS  |  WEBINARS  |  INDUSTRIES  |  FOCUS ON FUNDAMENTALS
  |  REGISTER  |  LOGIN  |  HELP
Blogs
Guest Blogs

Fastener Inserts Designed for Lightweight Aerospace Materials Reduce Risks, Costs

NO RATINGS
Page 1 / 3 Next >
View Comments: Newest First|Oldest First|Threaded View
<<  <  Page 2/2
Jerry dycus
User Rank
Gold
Fasteners in composites
Jerry dycus   12/27/2012 10:10:03 AM
NO RATINGS
 

              I'm not sure anything in this article is new as much if not all of it has been known for 50-100 yrs!!

              In composites one doesn't cut threads for either bolts or inserts if one is smart but instead molds them with epoxy, etc in place giving good holding and locking in many cases.  If a sandwiched material one hollows out the foam/etc core and fill it with epoxy to spead the load, then insert the bolt, insert, etc as needed.

              In other plastics drilling a smaller hole then screwing a hot bolt, insert into it  gives the needed strength in many cases.

              If higher loads than the local material can handle glue on a reinforcement piece with the threads built into it.

              As for working loose there are many types of thread lockers out there.

           

<<  <  Page 2/2
Partner Zone
More Blogs from Guest Blogs
Was Steve Job’s signature outfit of a black turtleneck, jeans, and sneakers the secret behind his success? Maybe, or maybe not, but it was likely an indication of a decision-making philosophy that enabled him to become one of the most successful innovators of all time.
Electromechanical actuators and propulsion system enable the first controlled landing and ascent from a solar system body other than the moon.
Combining energy-saving product design and advanced lithium batteries enables wireless devices to operate maintenance-free for up to four decades.
Hardware-in-the-loop test platforms enable manufacturers to deal with increasing software complexity.
Remember when design decisions for optimizing low-power MCU applications were simple? All you needed to do was select when to put the MCU into the low-power mode and when to wake it up. Once it was awake, you just ran the required code as quickly as possible. Simple, right? Well, these days designing for power efficiency isn’t so simple. Why is that the case?
Design News Webinar Series
2/25/2015 11:00 a.m. California / 2:00 p.m. New York
12/11/2014 8:00 a.m. California / 11:00 a.m. New York
12/10/2014 8:00 a.m. California / 11:00 a.m. New York
11/19/2014 11:00 a.m. California / 2:00 p.m. New York
Quick Poll
The Continuing Education Center offers engineers an entirely new way to get the education they need to formulate next-generation solutions.
Feb 23 - 27, Baremetal C Programming for Embedded Systems
SEMESTERS: 1  |  2  |  3  |  4  |  5  |  67


Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.
Learn More   |   Login   |   Archived Classes
Twitter Feed
Design News Twitter Feed
Like Us on Facebook

Sponsored Content

Technology Marketplace

Copyright © 2015 UBM Canon, A UBM company, All rights reserved. Privacy Policy | Terms of Service