Content tagged with Aerospace
posted in June 2009
SKF's President Johnstone Positive about Future
6/24/2009  Post a comment
Optimistic about the $8.5B U.S. company's future prospects
Tadiran's TLM Military Grade Lithium Batteries
6/16/2009  Post a comment
Feature low self-discharge, wide operating temperature range
Surveillance Relies on Unmanned Flying Vehicles
6/15/2009  Post a comment
Flight, payload technologies in pilotless MAVs drive their capabilities
'Engineering the Peace’
6/15/2009  Post a comment
Brig. Gen. Jeffrey Talley turned a Shiite slum into a peaceful place to live
Taking Small Micro Air Vehicles to the Next Level
6/15/2009  Post a comment
Wright State University researchers apply their expertise and stake their claim in MAV research and design
Boeing Wraps Phase 2 Of Gauntlet Tests for 787
6/12/2009  Post a comment
The intermediate gauntlet test scenarios put the ZA001 through its paces as if it were in flight
Model-Based Design Helps Aerospace Engineers
6/12/2009  Post a comment
Implementation improves design quality, reduces time and saves cost
Boeing Races to Redesign Weight Out of Dreamliner 787
6/8/2009  Post a comment
Range of the composite aircraft has been reduced 10 to 15 percent
Airbus Focuses More Closely on Flight 447 Pitot Tube Problems
6/8/2009  Post a comment
Questions arise regarding device's design and Air France's maintenance procedures
What Happened to Flight 447? A Designer's Worst Dilemma
6/5/2009  3 comments
As attention shifts to the pitot tubes that provide air-speed data, Airbus designers must be doing a lot of soul searching right now
Boeing 787 Dreamliner Completes First Engine Runs
6/1/2009  Post a comment
First flight expected at the end of June

Partner Zone
Latest Analysis
According to a Randstad Engineering compilation of salary studies, engineering salaries are increasing beyond inflation, with employers paying to keep potential suitors away from their employees.
The company says it anticipates high-definition video for home security and other uses will be the next mature technology integrated into the IoT domain, hence the introduction of its MatrixCam devkit.
Siemens and Georgia Institute of Technology are partnering to address limitations in the current additive manufacturing design-to-production chain in an applied research project as part of the federally backed America Makes program.
Most of the new 3D printers and 3D printing technologies in this crop are breaking some boundaries, whether it's build volume-per-dollar ratios, multimaterials printing techniques, or new materials types.
Check out these gifts that will make you the hero of your Secret Santa party.
Design News Webinar Series
11/10/2015 11:00 a.m. California / 2:00 p.m. New York
10/29/2015 11:00 a.m. California / 2:00 p.m. New York
10/20/2015 8:00 a.m. California / 11:00 a.m. New York
12/2/2015 11:00 a.m. California / 2:00 p.m. New York
Quick Poll
The Continuing Education Center offers engineers an entirely new way to get the education they need to formulate next-generation solutions.
Jul 6 - 10, Building Raspberry Pi Controllers with Python
SEMESTERS: 1  |  2  |  3  |  4  |  5  |  6 |  7

Focus on Fundamentals consists of 45-minute on-line classes that cover a host of technologies. You learn without leaving the comfort of your desk. All classes are taught by subject-matter experts and all are archived. So if you can't attend live, attend at your convenience.
Learn More   |   Login   |   Archived Classes
Twitter Feed
Design News Twitter Feed
Like Us on Facebook

Sponsored Content

Technology Marketplace

Copyright © 2015 UBM Canon, A UBM company, All rights reserved. Privacy Policy | Terms of Service